rob@triggermeister.com

Month: October 2011

For the love of guns...

Reloading Stand: No shake, rattle or roll

So, this weekend I fixed another issue that had been bugging me for a while.  For my reloading area I have a wooden bench that was sturdy but would still flex under the pressure of the press when cranked.  I see this issue often on Youtube videos and it leads to spilled powder and cases…
Read more

UPDATE: Making the Hornady Case Feeder “GLOCK FRIENDLY”

At first I was going to just modify my original post, but then I figured this deserved it’s own post.  If you find yourself in the situation where your .40 cal Glock brass will not fall down the small clear tube, you have an alternative now!  While some of us have come up with different…
Read more

Make your own Hornady EZject Sub-Plate

Hello, again.  ’tis is the season for reloading once again!  I’ve probably run about 8000 rounds through my Hornady LNL Progressive Press since the last major reloading post and shot about 6000 rounds in that time, excluding .22’s of course.  Now, it is back to bulk reloading for the winter to get me caught up for next…
Read more